Rockwell Automation 1756-OF8H ControlLogix HART Analog I/O Modules - Manual (Page 108)

108 Rockwell Automation Publication 1756-UM533C-EN-P - February 2011
Chapter 7 Configure the Modules with RSLogix 5000 Software
Output State in Program Mode
These parameters are not available in Hard Run mode.
Output State in Fault Mode
These parameters are not available in Hard Run mode.
The module enters Program mode state if the Connection from Logix is
inhibited. If communication subsequently fails, all channels of the module remain
in Program mode.
The output signal goes to Fault mode when the controller faults or when
communication between an output module and its controller is lost. Output
State in Fault Mode appears dimmed in Hard Run mode.
Selecting Configures the Output Channel for the Following When
the Controller Transitions from Run to Program Mode
Hold Last State Leave the current output at its last value.
User Defined Value Go to the specific value when the owner controller is switched
into Program mode. If you select this, enter a value from
9,999,999…99,999,999, default is 0.
Ramp to User
Defined Value If Hold Last State - this field is disabled.
User Defined Value - check if you want the output to ramp to the
user-defined value at the specified ramp rate. The ramp rate is
selected from the output Limits tab.
If unchecked, output signal steps to the User Defined Value
immediately on entering Program mode.
Select To configure the output module to one of these
Hold Last State Leave the output signal at its last value.
User Defined Value Go to a specific value if a fault occurs. If you click this button, enter a value
from -9,999,999…99,999,999, default is 0.
Ramp to User Defined
Value If Hold Last State - This field is disabled.
If User Defined Value - You can check this if you want the output to ramp to
the user-defined value at the specified ramp rate. The ramp rate is selected
on the output Limits tab.
If unchecked, the output signal steps to the user-defined value immediately
on entering Fault mode.