Rockwell Automation 1756-OF8H ControlLogix HART Analog I/O Modules - Manual (Page 36)

36 Rockwell Automation Publication 1756-UM533C-EN-P - February 2011
Chapter 2 Module Installation
Remove the Removable
Terminal Block
Before removing the module, you must remove the RTB.
1. Unlock the locking tab at the top of the module.
2. Open the RTB door and pull the RTB off the module.
ATTENTION: The RTB is designed to support removal and insertion under
power (RIUP). However, when you remove or insert an RTB with field-side
power applied, unintended machine motion or loss of process control can
occur. Exercise extreme caution when using this feature. We recommended
that field-side power be removed before removing the module.
42517
20855