Rockwell Automation 1756-OF8H ControlLogix HART Analog I/O Modules - Manual (Page 34)

34 Rockwell Automation Publication 1756-UM533C-EN-P - February 2011
Chapter 2 Module Installation
Wire the Module Refer to the individual module chapters for wiring information.
Removal Terminal Block
Assembly and Installation The following sections describe the steps needed to assemble and install the RTB.
Assemble the Removable Terminal Block and the Housing
1. Align the grooves at the bottom of each side of the housing with the
side edges of the RTB.
2. Slide the RTB into the housing until it snaps into place.
For this module Page
1756-IF8H 60
1756-IF16H 72
1756-OF8H 83
1
4
3
2
3
2
20858-M
Item Description
1 Housing cover
2 Groove
3 Side edge of RTB
4 Strain relief area