Rockwell Automation 1756-OF8H ControlLogix HART Analog I/O Modules - Manual (Page 160)

160 Rockwell Automation Publication 1756-UM533C-EN-P - February 2011
Chapter 11 Module Troubleshooting
Module Configuration
Errors The additional fault code value describes the configuration error if
“(Code 16#0009) Module Configuration Rejected: Parameter Error” is
displayed on the Connection Tab in RSLogix 5000 software.
Additional Fault Codes - Module Level
Table 51 shows error codes used by ControlLogix HART Analog modules for
module level conditions (conditions that do not occur in a specific channel).
Table 51 - 1756-IF8H, 1756-IF16H, and 1756-OF8H Module Level Error Codes
Additional Fault Codes Description
16#0001 Configuration revision number invalid
Valid numbers are 0 or 1
16#0002 Filter value invalid
16#0003 RTS invalid
16#0004 Pass-through handle timeout
16#1001 Configuration does not match
In a multiple owner setup, with the configuration revision
number set to 1, the configurations must match
TIP The 16# means this number is Hex display style.