Metrohm 815 Robotic Soliprep - Manual (Page 119)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Robotic Filtration Soliprep 2.815.3110
815 Robotic Soliprep
￭￭￭￭￭￭￭￭ 111
1 ￭ Connect the connecting cable of the dispersion device to the
front of the control module.
2 ￭ Check the set supply voltage on the connection socket on the rear
side of the control module.
￭ Switch off the instrument.
￭ Plug in the power supply cable and connect to a socket.
3 ￭ Connect the 6.2134.110 RS-232 connection cable to the 9-pin
connection socket on the rear side of the control module.
￭ Plug in the other end of the cable to the COM1 or COM2 port on
the PC. The port on the PC is usually marked with IOIOI.
If the PC has no serial interface, then a USB port on the PC can be
used with the aid of an RS-232/USB converter (e.g. the
2.145.0320 Edgeport).
Note
The Polytron must be registered manually in tiamo™ as an RS-232
device.
4.1.17 Mounting the safety shield
Safety shield 6.2751.150
The 815 Robotic Soliprep may not be operated without a safety shield.
Install it as follows:
1 Mounting the spacer for the safety shield with the screws supplied to
tower 1 according to the following figure.
1
2 Unscrew the black nuts on both sides of tower 1.