Metrohm 815 Robotic Soliprep - Manual (Page 27)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2 Robotic Titration Soliprep 2.815.1110
815 Robotic Soliprep
￭￭￭￭￭￭￭￭ 19
2.1.7 Opening the guide chain
Tubings and cables can be placed into the guide chain of the towers.
You can open the individual chain links with a screwdriver as follows.
1 Opening the guide chain
￭ Insert a screwdriver into the groove located on the side of a chain
link.
￭ Loosen the clip with a forceful leverage movement.
￭ Pull the clip out of the chain by hand.
￭ Repeat the above actions for each chain link.
2 Inserting into the guide chain
￭ Place the required tubings and cables into the guide chain.
3 Closing the guide chain
￭ Close the clip of each chain link again by hand and apply forceful
pressure to snap them into place.
Caution
Take care to ensure that any cables and tubings that are fixed in the
guide chain are not in a position to hinder the free movement of the lift
or of the robotic arm. This could lead to damage to the affected drive.
If the 6.1462.070 robotic arm for titration is used, we recommend that
the clips in the first and second chain links be removed completely.
Loosen both sides of the respective clip for this purpose as described
above.