Metrohm 815 Robotic Soliprep - Manual (Page 138)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
130 ￭￭￭￭￭￭￭￭
815 Robotic Soliprep
5 Controlling the Polytron ®
Configuration
Once the Polytron has been set up, it can be configured in tiamo.
Configuring the Polytron
1 Click on the Configuration symbol.
2 Click on [Edit] in the Devices window.
3 Select the entry New... in the pull-down menu and then set up a
new RS 232 device in the device selection under Miscellaneous.
4 Enter a device name and the device serial number of the Polytron
under General.
5 Enter the following settings in the RS 232 dialog window:
￭ COM Port = COM1 (i.e. the interface on the PC to which you
have connected the Polytron)
￭ Baud rate = 2400
￭ Data bit = 8
￭ Parity = none
￭ Stop bit = 1
￭ Handshake = none
￭ Timeout = 2000 ms
￭ Terminator for send = \0D\0A (= CR LF)