Metrohm NIRS XDS Process Analyzer – MicroBundle User Manual
Page 104
Advertising
102
▪▪▪▪▪▪▪
4.
Gently lift the tab to open each fuse
position. Spare fuses are included in the
instrument Accessory Kit.
Fuse Ratings:
•
250 VAC, 5 x 20mm, Slo-Blo
(2) Required
•
Non-Air Conditioned: 3.15A
•
Air-Conditioned:
6.3A
Order spare fuses immediately, to have on hand.
5.
Remove each fuse from the clip.
It may help to push the fuse, using a
pencil eraser, from the side shown, and
then grasp the fuse to fully remove.
Inspection of the blown fuses may
provide some information about the type
of fault. Use this information to help
eliminate the cause of the problem.
Discard old fuses immediately.
6.
Install new fuses as shown. The fuses clip
into the holder, and will be retained in
position.
Advertising