Metrohm NIRS XDS Process Analyzer – MicroBundle - Manual (Page 45)

▪▪▪▪▪▪▪ 43
Install the O-ring onto the cable connector
housing as shown. Do not damage or distort the
O-ring during installation.
Slide the cable connector housing onto the RJ-45
cable as shown.
Using the correct type of crimping tool, crimp the
RJ-45 connector jack onto the cable. Be sure the
conductors are arranged in the proper order and
are in the designated positions for crimping.
Push the RJ-45 jack fully into the connector
housing. Install the locking clip as shown to hold
the jack to the connector housing.
Note that the locking clip must be oriented as
shown, with the flat center projection toward the
jack. When in place, push down fully.
Tighten the hex collar onto the connector
housing. Apply enough torque to fully compress
the seal over the cable end.