Baseline Systems BaseStation 3200 - Manual (Page 35)

C h a p t e r 1 – G e t t i n g S t a r t e d
Page 33
Baseline 3200
Assigning biSensors to Primary Zones
Refer to Section 2, Moisture Based Watering below for instructions to assign sensors to Primary
Zones.
Setting the Controller Date and Time
To set or change the controller date and time,
turn the dial to the Date/Time menu, then use
the +/- and NEXT/PREV keys to set or change
each field as desired.
Warning: changing the date and time can cause
watering events to be missed!
Note that all menu screens on the 3200 include
specific help text to tell you what to do next.
Auto Run Main Screen
The Main Screen is shown while the dial is in the
Auto Run position, and shows status for all
elements of the 3200 controller.
Air Temp: will show “None” if no air temperature
sensor connected to the system, otherwise will
show current air temperature.
Remote: indicates the status of remote
communications to the 3200. Possible indicators
include:

None: No remote communication
devices were detected.

Idle: One or more remote communication devices were detected, but none are in use
at this time.

BL Commander: A BL Commander remote control is currently active.

BaseManager: BaseManager central control software is currently connected to and
communicating with the controller.
Two-wire: indicates the active electrical current on the Two-wire. This will indicate 0.00 Amps
when two-wire is off,
Flow: shows the real-time flow readings in GPM. If multiple flow sensors are connected to the
system, this indicator will cycle through each flow sensor.
Prog: Shows the status of all programs. The color indicator will cycle through the meaning of
each color, and this is shown on the inside door label of the controller.
MV: Shows the status of each master valve.
Zone Status: Shows the status of each zone.