Baseline Systems BaseStation 3200 - Manual (Page 76)

C h a p t e r 5 – R e f e r e n c e
Page 74
Baseline 3200
and offset and when found during a search operation, will auto-program these values into the
controller providing instant operation.
Standard sizes include: 1”, 1.5”, 2”, 3” and 4”.
Hydrometer
There are three lines of brass hydrometers:

The BL-BFM line of flow meters are industrial brass
for long life and high durability. They are two-wire
ready and are pre-programmed with the K-value
and offset and when found during a search
operation, will auto-program these values into the
controller providing instant operation. They come
in three sizes, 0.75”, 1” and 1.5”.

The BL-BHM line of flow meters are industrial brass
for long life and high durability, and have a built-in
normally closed master valve. They are two-wire
ready and are pre-programmed with the K-value and offset and when found during a
search operation, will auto-program these values into the controller providing instant
operation. They come in four sizes, 1”, 2”, 3” and 4”.

The BL-BHM-NO line of flow meters are industrial brass for long life and high
durability, and have a built-in normally open master valve. They are two-wire ready
and are pre-programmed with the K-value and offset and when found during a search
operation, will auto-program these values into the controller providing instant
operation. They come in four sizes, 1”, 2”, 3” and 4”.
Soil Moisture biSensors
The patented Baseline soil
moisture biSensor provides an
accurate and repeatable
moisture reading under a
variety of conditions and soil
mixtures. When buried in the grass root zone, it provides continual feedback to the controller of
the moisture and soil temperature. These values and used with advanced algorithms to
determine the best adjustments to the base watering schedule to keep the grass healthy while
using only the water needed for a green and healthy lawn.
The biSensor is connected to the two-wire at a convenient location.
Pause biCoder
The pause biCoder allows the water schedule of a program, or
set of programs to be paused based on a set of contacts
connected to the pause biCoder. These contacts can be a
switch, or a float in a tank, a wind switch, or any sensing device
with a set of normally closed contacts.