Baseline Systems BaseStation 3200 - Manual (Page 58)

C h a p t e r 5 – R e f e r e n c e
Page 56
Baseline 3200
block of fifty zones, press the + key. The + and – keys can be used to navigate among
each block of fifty zones.
There are several additional status screens that are available with the dial in this position. They
can be accessed using the NEXT/PREV keys.

Detailed Program Status – this screen
shown to the right shows some
additional information about
program A. For convenience, the
mainline assignment is also indicated
next to the program letter. While on
this screen, the other programs can
be viewed by pressing the + key to
scroll through each of the status
summaries. Pressing the NEXT key
will move to the next status category.

Moisture biSensor Chart – each of
the biSensors in the system can be
viewed in a two week chart showing
the moisture levels for four intervals
during each day. Also indicated on
the chart is either the upper or lower
limit. The lower limit is indicated by
a green line (start watering) and the
upper limit is shown by a red line
(stop watering). The biSensor serial
number is displayed at the bottom of
the graph and the current moisture
reading is displayed along the top.
Use the + or – keys to change the
biSensor being displayed. Pressing
the ENTR key will change the vertical
moisture graph range to higher or
lower moisture ranges can be seen.
Press the NEXT key to move to the
next status screen.

Flow Device Status – these screens
provide information about water
used as measured by the flow device,
as can be seen in the sample screen
to the right. There is a screen for
each of the flow devices configured in
the system. Use the + or – keys to
scroll between each of the flow
device status screens. Press the NEXT
key to move to the next status
screen.

Pause Status Screen – this screen is
only available when there is an active
pause or controller stopped
condition. If there are multiple pause