Baseline Systems BaseStation 3200 - Manual (Page 68)

C h a p t e r 5 – R e f e r e n c e
Page 66
Baseline 3200
AUX – Rain/Off
This function will stop all water for a specified
number of days. Setting the days to one, will
stop watering for the rest of the day, and will
resume normal watering at midnight.
The number of delay days may be set between 1
and 365. Use the + and – keys to set the number
of days to delay watering.
Once a Rain/Off stop watering is active, it may be
cleared by entering this menu and setting the
number of days to zero, or by viewing the
pause/stop status from the main screen (dial in
the Auto/Run position) and pressing the CLR key. Please refer to page 56, Pause Status Screen.
AUX – Temp/Pause
This menu will display the presence of an air temperature sensor if one is connected to the two-
wire. This screen has a search function to find two-wire devices.

To remove a two-wire
device, you must physically
diconnect it from the two-
wire and then perform a
Search operation from the
device specific menu. This
means a biSensor can only
be removed by doing a
search from the biSensor
menu, etc..
AUX – Passcodes
The BaseStation 3200 has two levels of access for
BaseManager central control access: read-only
and read-write access. These are set in the
Passcodes screen in the AUX dial position.
When the first menu item is highlighted, it can be
changed bewteen Read/Write and Read Only by
use the + or – keys. Use the NEXT/PREV keys to
move between the digits of the passcode and
thenh modify them to form your own unique
access codes.
This setp is not needed if the controller will be
used totally standalone and will not be accessed from the BaseManager central control software.
It is important that the codes be changed from their default values to allow access to those
authorized and to restrict further those able to make programming changes.