Baseline Systems BaseStation 3200 - Manual (Page 61)

C h a p t e r 5 – R e f e r e n c e
Page 59
Baseline 3200

Calibrate Failure: saturation not reached

Water flow rate has exceeded limit

Learn Flow Zone Successful

Watering Stopped by Low Temperature

The valve is an open-circuit

The valve current is too high

Pause biCoder has paused watering

Pause Switch has paused watering

Insufficient time between program starts

Rain/Off Delay has stopped watering

Rain Switch has stopped watering

The valve is a short-circuit

The Start Time was Skipped

Two-wire Current is too High

Unscheduled Flow exceeded limit

Water Window has stopped watering

Zone flow exceeds design flow

High Flow has terminated zone watering

Low Flow has terminated zone watering
Zone Water Times
This dial position is used to configure zones after
they have been assigned to a valve decoder. Refer
to the sample screen to the right for the following
field functions.

Press ENTR to quickly move to the next zone.

Zone – when highlighted use the + and – keys to change the zone number to be
programmed.

Enabled – use this to enable a zone for normal operation. A single zone can be
disabled to keep it from running during maintenance or other conditions.

Zone Mode – there are three modes for zones in the BaseStation 3200
Timed

This is the default for newly assigned zones and in this mode it
can be programmed and will water in an independent manner
(like other clocks).