Baseline Systems BaseStation 3200 - Manual (Page 44)

C h a p t e r 2 – B a s i c P r o g r a m m i n g
Page 42
Baseline 3200

Program start time

Valid water day

If a moisture biSensor is used, then the moisture level at the program start time is less
than the limit

There isn’t an event day

There isn’t a rain sensor stop condition

There isn’t another controller stop condition (high flow shut-down, etc.)
The program will run to completion, spanning days if needed. The running program may be
paused for some period of time by one of the following conditions, after which it will resume
until it has completed:

Water window (white square)

Pause switch or pause biCoder

Turning the dial to make a programming change – when the dial is left in a
programming position, the controller will return to run mode in two hours just as if
the dial had been move back to Auto/Run.
If there are specific days that can’t be used for watering then there are a couple of ways to
address this:

Start programs after midnight and provide enough time for them to complete during a
single day so they don’t span into the next day.

Use water windows to block out specific days,