Dell POWEREDGE M1000E - Manual (Page 41)

Fabric OS Message Reference 19
53-1002749-01
Displaying system message logs and attributes
1
Displaying Audit messages
To display the Audit messages, perform the following steps. Beginning with Fabric OS v7.1.0
release, the RAS-3005 message is generated for each CLI command executed on switch and is
saved in the Audit message log.
1. Log in to the switch as admin.
2. Enter the auditDump -s command at the command line.
switch:admin> auditdump -s
0 AUDIT, 2011/01/14-06:06:49 (UTC), [RAS-2001], INFO, SYSTEM,
admin/admin/192.0.2.2/telnet/CLI, ad_0/switch/FID 128, , Audit message log is
enabled.
2 AUDIT, 2011/01/14-06:07:03 (UTC), [SEC-3020], INFO, SECURITY,
admin/admin/192.0.2.2/telnet/CLI ad_0/switch, , Event: login, Status: success,
Info: Successful login attempt via SERIAL.
3 AUDIT, 2011/01/14-06:07:33 (UTC), [SULB-1003], INFO, FIRMWARE,
admin/admin/192.0.2.2/telnet/CLI ad_0/switch, , Firmwarecommit has started.
4 AUDIT, 2011/12/11-10:08:58 (UTC), [SULB-1004], INFO, FIRMWARE,
admin/admin/192.0.2.2/telnet/CLI ad_0/switch, , Firmwarecommit has completed.
5 AUDIT, 2012/05/23-03:45:15 (UTC), [RAS-3005], INFO, CLI,
admin/admin/NONE/console/CLI, ad_0/switch/CHASSIS, , CLI: clihistory --all
6 AUDIT, 2012/05/23-04:12:04 (UTC), [RAS-3005], INFO, CLI,
admin/admin/NONE/console/CLI, ad_0/switch/CHASSIS, , CLI: auditdump -s
[...]
Displaying FFDC messages
To display the saved FFDC messages, perform the following steps.
1. Log in to the switch as admin.
2. Enter the errDump --attribute FFDC command at the command line.
switch:admin> errDump --attribute FFDC
Fabric OS: v7.1.0
2012/10/15-10:39:02, [LOG-1002], 4496, FFDC, WARNING, switch, A log
message was not recorded.
2012/10/15-10:39:18, [RAS-1001], 4496, FFDC, WARNING, switch, First
failure data capture (FFDC) event occurred.
[...]