Dell POWEREDGE M1000E - Manual (Page 458)

436 Fabric OS Message Reference
53-1002749-01
FSSM-1002
5
FSSM Messages
FSSM-1002
Message HA State is in sync.
Message Type LOG
Severity INFO
Probable Cause Indicates that the high availability (HA) state of the active control processor (CP) is in synchronization
with the HA state of the standby CP. If the standby CP is healthy, the failover will be nondisruptive.
Recommended
Action
No action is required.
FSSM-1003
Message HA State out of sync.
Message Type LOG
Severity WARNING
Probable Cause Indicates that the high availability (HA) state of the active control processor (CP) is out of synchronization
with the HA state of the standby CP. If the active CP failover occurs when the HA state is out of
synchronization, the failover is disruptive.
Recommended
Action
If this message was logged as a result of a user-initiated action (such as running the reboot command),
no action is required.
Otherwise, execute the haSyncStart command on the active CP to resynchronize the HA state.
If the HA state does not synchronize, execute the haDump command to diagnose the problem.
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
FSSM-1004
Message Incompatible software version in HA synchronization.
Message Type LOG
Severity CRITICAL
Probable Cause Indicates that the active control processor (CP) and the standby CP in a dual CP system are running
firmware that is incompatible with each other. If the active CP fails, the failover will be disruptive.
In a switch system, this message is logged when a firmware upgrade or downgrade was invoked. The
new firmware version is not compatible with the current running version. This causes a disruptive
firmware upgrade or downgrade.