Rice Lake 720i Programmable Indicator/Controller - Installation Manual - Manual (Page 46)

40 720i Installation Manual
HEARTBEAT OFF, 0.5—4.0 Specifies, in seconds, the rate of the heartbeat signal sent from the host to the display
module. The heartbeat is used to verify active communications between the host and the
display and to ensure that the displayed data is current.
If specified, the display module input heartbeat (HB1:I parameter) must also be set,
typically to a value slightly longer than the host HEARTBEAT parameter. (For example,
HEARTBEAT=1.5, HB1:I=2.0.) See Section 11.11 on page 110 for more information about
configuring the display module.
LOCALE OFF
ON Locale. Set this parameter ON to enable the LATUDE and ELEVAT parameters. Specifying
latitude and elevation of the scale site provides compensation for gravitational effects.
Attached scales must be recalibrated after changing this parameter from OFF to ON.
LATUDE 45
0–90 Latitude. Specify the latitude of the scale site in degrees. This parameter is shown only if
LOCALE=ON.
ELEVAT 345
±0–9999 Elevation. Specify the elevation of the scale site in meters. Valid values are –9999 through
9999. This parameter is shown only if LOCALE=ON.
Level 3 submenus
DATEFMT MMDDYYYY
DDMMYYYY
YYYYMMDD
YYYYDDMM Specifies the format used to display or print the date.
DATESEP SLASH
DASH
SEMI Specifies the date separator character.
TIMEFMT 12HOUR
24HOUR Specifies the format used to display or print the time.
TIMESEP COLON
COMMA Specifies the time separator character.
SHIFT 1 - 3 SHIFT # START
SHIFT # END Specifies the shift start and end time in 24 hour format (HHMMSS)
DAY START
DAY END HHMMSS
HHMMSS Specifies the day start and end time in 24 hour format (HHMMSS)
FEATURE Menu
Parameter Choices Description
Table 3-7. FEATURE Menu Parameters (Continued)