Rice Lake 720i Programmable Indicator/Controller - Installation Manual - Manual (Page 69)

Truck Modes 63
7.6.1 Advance Mode Menus
Advance Mode Reports Menu
In Advance Mode the Weigh , Reports and Management softkeys are enabled. The Reports softkey is described
below.
WEIGH REPORTS MANAGEMENT
DDMMYYYY
MATERIAL
CUSTOMER SINGLE ID
ALL
DAILY
DDMMYYYY
SHIFT
ALL
SHIFT 2
SHIFT 1
DETAIL
PENDING
ALL
CODE LIST
CUSTOMER
MATERIAL
SUMMARY
SOURCE
SOURCE
SHIFT 3
REPORT START
REPORT END DAY
Note
While in a submenu the TARE key can be pressed to go back to the previous menu. If using the PS2
keyboard, the ESC key will take you to the previous menu.
Figure 7-4. Reports Menu
Table 7-6. Reports Menu Parameters
Print Menu
Parameter Choices Description
Level 2 submenus
SUMMARY REPORT START
REPORT END DAY Report from beginning date to ending date specified by the operator. (DDMMYYY)
Report by material, customer or source
DAILY REPORT DAY Report of selected date entered by operator, can be all transactions or by a selected
shift (1, 2 or 3)
DETAIL ALL
PENDING All transations in the database or pending transactions only
CODE LIST MATERIAL
CUSTOMER
SOURCE List of stored items by material, customer or source
Level 3 submenus
MATERIAL ALL
SINGLE ID Specifies the material for the Summary Report
CUSTOMER ALL
SINGLE ID Specifies the customer for the Summary Report
SOURCE ALL
SINGLE ID Specifies the source of the Summary Report
ALL - Prints all shifts for the Daily Report
SHIFT SHIFT 1
SHIFT 2
SHIFT 3 Prints select shifts for the Daily Report