Rice Lake 720i Programmable Indicator/Controller - Installation Manual User Manual
Page 66
60
720i Installation Manual
In Advance Mode the
Weigh
,
Reports
and
Management
softkeys are enabled. Softkeys are described below.
Weigh
Reports
Management
12880
lb
G
Figure 7-3.
720i Display, showing Advance Mode Softkeys
Weigh
Start the Weigh-In and Weigh-Out
P r o c e d u r e . S e e “ A d v a n c e M o d e
Weigh-In Procedure” on page 62.
Reports
Select which report to print. There are
four sub menus under the
R e p o r t s
softkey:
Summary
,
Daily
,
Detail
, and
Code List
.
Management
Add and remove materials, customers,
and source IDs and names.
While in a submenu the
TARE
key can be pressed to go
back to the previous menu. If using the PS2 keyboard,
the
ESC
key will take you to the previous menu.
On Weigh-In the AUX1FMT is printed.
On Weight-Out the AUX2FMT is printed.
When printing Shift/Day and Detail All/Pending
reports:
•
AUX3FMT is the header
•
AUX4FMT is each line for each transaction
•
AUX5FMT is the footer/total lines
When printing Summary Reports:
•
AUX6FMT is the header
•
AUX7FMT is the header for Source Reports
•
AUX8FMT is the header for Customer Reports
•
AUX9FMT is the header for Material Reports
•
AUX10FMT is each line for each transaction
for Source Reports
•
AUX11FMT is each line for each transaction
for Customer Reports
•
AUX12FMT is each line for each transaction
for Material Reports
•
AUX13FMT is the sub total line
•
AUX14FMT is the footer/total lines
When printing the Code list reports:
•
AUX15FMT is the header
•
AUX16FMT is printed for the Source
•
AUX17FMT is printed for the Customers
•
AUX18FMT is printed for the Materials
Print Format Commands
When the ADVANCE mode is selected the AUX
formats are changed to generic in/out formatting. This
can be changed using an EDP command. See “Advance
Mode EDP Commands” on page 97.
To see the configuration of the AUX format send:
AUXFMT.FMT#n (where n is the aux format number)
To change the format serially send:
AUXFMT.FMT#n=<><><><CR>
Table 7-3. Print Format Commands
Command
Description
Characters
<TID>
Truck ID
12
alpha numeric
<MID>
Material ID
10
numeric only, no
decimals
<MN>
Material Name /
Description
30
alpha numeric
<CID>
Customer ID
10
numeric only, no
decimals
<CSN>
Customer Name /
Description
30
alpha numeric
<SID>
Source ID
10
numeric only, no
decimals
<SD>
Source Name /
Description
30
alpha numeric
<DN>
Delivery / Challan
Number
15
alpha numeric
<DW>
Delivery / Challan
Weight
Floating Point 9
Characters
<TC>
Remarks /
Comments
30
alpha numeric
<VD>
Vehicle ID /
Description
10
alpha numeric
<TDO>
Time / Date Out
18
<TDI>
Time / Date in
18
<RT>
Report Type
24
<JN>
Julian Date Number
Floating Point with 5
Decimal Places
<TCN>
Ticket Consecutive
Number / Serial
Number
numeric