Rice Lake 720i Programmable Indicator/Controller - Installation Manual - Manual (Page 98)

Table 10-8. ALGOUT Serial Commands (Valid Only If Analog Output Card Is Installed)
Command Description Values
ALG.ALIAS#n Analog output alias name
ALG.SOURCE#n Analog output source SCALEn
ALG.MODE#n Mode GROSS, NET
ALG.OFFSET#n Zero offset 0%, 20%
ALG.ERRACT#n Error action FULLSC, HOLD, ZEROSC
ALG.MIN#n Minimum value tracked 0–9999999
ALG.MINNEG#n Minimum negative value tracked OFF, 0–9999999
ALG.MAX#n Maximum value tracked 0–9999999
ALG.MAXNEG#n Maximum negative value tracked OFF, 0–9999999
ALG.ZERO#n Zero calibration 0–65535
ALG.SPAN#n Span calibration 0–65535
#n indicates the slot number assigned to the analog output. Single-channel cards are assigned ALGOUT2.
92 720i Installation Manual
Command Description Values
SP.KIND#n Setpoint kind OFF, GROSS, NET, –GROSS, –NET, ACCUM, ROC, +REL, –REL,
%REL, RESREL, PAUSE, DELAY, WAITSS, COUNTER, AUTOJOG,
COZ, INMOTON, INRANGE, BATCHPR, TIMER, CONCUR, DIGIN,
AVG, TOD, DELTA, CHWEI, PLSCNT, PLSRAT, ALWAYS, NEVER,
DINCNT
SP.VALUE#n Setpoint value number
SP.SOURCE#n Source scale SCALE1
SP.COAST#n Pulse counter coast number
SP.TRIP#n Trip HIGHER, LOWER, INBAND, OUTBAND
SP.BANDVAL#n Band value number
SP.HYSTER#n Hysteresis number
SP.PREACT#n Preact type OFF, ON, LEARN, FLOW
SP.PREVAL#n Preact value number
SP.PREADJ#n Preact adjustment percentage number
SP.PRESTAB#n Preact learn stability number
SP.PCOUNT#n Preact learn interval number
SP.TOLBAND#n Target tolerance number
SP.TOLCNT#n Tolerance count number
SP.BATCH#n Batch step enable OFF, ON
SP.CLRACCM#n Clear accumulator enable OFF, ON
SP.CLRTARE#n Clear tare enable OFF, ON
SP.PSHACCM#n Push accumulate OFF, ON, ONQUIET
SP.PSHPRINT#n Push print OFF, ON, WAITSS
SP.PSHTARE#n Push tare OFF, ON
SP.ALARM#n Alarm enable OFF, ON
SP.NAME#n Setpoint name number NONE, 1–30
SP.ACCESS#n Setpoint access OFF, ON, HIDE
SP.DSLOT#n Digital output slot NONE, SLOTx
SP.DIGOUT#n Digital output BITx