Rice Lake 720i Programmable Indicator/Controller - Installation Manual - Manual (Page 86)

80 720i Installation Manual
To begin a batch process, turn the 3-way switch to
START momentarily. If the STOP button is pushed
during the batch process, the process halts and the
button locks in the IN position.
The START switch is ignored while the STOP button is
locked in the IN position. The STOP button must be
turned counterclockwise to unlock it, then released into
the OUT position to enable the 3-way switch.
To restart an interrupted batch from the step where it
left off, do the following:
1. Unlock STOP button (OUT position)
2. Turn 3-way switch to START
To restart an interrupted batch from the first batch step,
do the following:
1. Turn 3-way switch to ABORT
2. Unlock STOP button (OUT position)
3. Turn 3-way switch to START
Note
Use this procedure (or the BATRESET serial
command) to initialize the new batch routine
following any change to the setpoint
configuration.