Roland 24 bit Digital Studio Workstation VS-890 - Manual (Page 11)

Preparations
Turning On the Power
The rear panel POWER switch turns on the power of the
VS-890. When the VS-890 starts up correctly, the following
display will appear.
f-------------------------------------
C0MXT10N hUmERf
>
P l y 0 0 0 00h00n00S00
WEABWe KAT
1 1
I l f f
---
294I400.
1 a!3«se78 A8 Un
0
4
m
2A
48
's_____________________
WPin’/TRACK lux UACTER
J
2
3
Turn on the power of your audio system.
Raise the volume of your audio system to an appropriate level.
Always make sure to have the volume level turned down before switching
on power. Even with the volume all the way down, you may still hear some
sound when the power is switched on, but this is normal, and does not
indicate a malfimction.
If the Display Indicates “lnit.Drive=NoDrv’
No hard disk is installed. In this case, the VS-890 cannot be used.
If this message appears even though a hard disk has been installed, the hard
disk is not being detected correctly. Use the rear panel power switch to turn
off the VS-890, check that the hard disk is installed properly.
CCMJCXTiON MARKER# ^^|||||||||||||||||^
SVS Init.Driue =NoDru
-da
MEASURE BEAT 1
ll 0
2|
SYNC MODE aCEt« 3|
4
4i si ¡s
l^ilANiNS TWE Si
0™000.:i
* t Z 3 4 9 e r s A & LR
24
48
INPUT/TRACK AUX MASTER
Once the connections have
been completed (p. 10),
turn on power to your
various devices in the order
specified. By turning on ;
devices in the wrong order,
you risk causing
malfunction and/or
damage to speakers and
other devices.
When the power is turned
on, the disk drive will be
detected, and necessary
data will be read. For this
reason there will be an
interval of time before
operation can begin.
1 1