Roland 24 bit Digital Studio Workstation VS-890 - Manual (Page 93)

Raise and lower channel fader 6, and verify that the volume
changes. The input channel fader is used to make fine
adjustments to the recording level. In order to record with
optimal audio quality, the fader should normally be set in the
0 dB position.
Press the [SELECT (CH EDIT)] button of the channel to which
you wish to apply the effect. For this example, press the input
channel 6
[SELECT (CH EDIT)] button. [SELECT (CH EDIT)]
will light.
Hold down [SHIFT] and press [EFFECT-2 (CH EDIT)].
Press PARAMETER [ ◄◄ ]. "FX2 Ins =" appears in the
display.
Rotate the TIMEAfALUE dial to turn the effect on/off. Select
"Insert."
CONDfTKJN MAfWER#
IH6F>i2 Ins = Insert
SEAT V
1 1 :!,
SYNC MODE SCENE
I NT -
tBAAlMNQTaiC
Z‘94„400,
T 2 3 4 5 0 7 S A B L R
INPUT/TRACK AUX MASTER
Using Effects
If the display indicates
"FX2—>" the effect (FX2) is
inserted into another
channel, and therefore
cannot be inserted into this
channel (p. 91). Either turn
off effect insertion for the
channel that is using the
effect or insert a different
effect into this channel.
Press [EFFECT] several times until "EFFECT-2 PRM ?"
appears in the display.
Press [YES (ENTER)]. The number and name of the currently
selected effect will be displayed, and you will be able to select
the effect.
Rotate the TIME/VALUE dial to select the effect you wish to
use. For this example, select an effect such as
"A41=GT:RockLead."
at