Making a multi-track recording, Init drive (initialize drive), Parameter – Roland 24 bit Digital Studio Workstation VS-890 User Manual
Page 70: Timea^alue dial, Physical fmt fphysical format), Partition, As needed, use, And the, Svsphysicalfnt= off, Svs p.artition=1000mb -ds
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Making a Multi-Track Recording
Init Drive (Initialize Drive)
Select the disk drive (IDE, SCSI0-SCSI7). "The internal hard disk will be
shown as "IDE," and external disk drives will be shown as "SC0-SC7." The
number following each disk drive indicates the partition number.
5
5 8
If you accidentally delete
data that you need, that
data cannot be restored to
its previous condition.
Roland Corporation
assumes no liability
concerning such loss of
data.
When a single hard disk or
other disk is divided into
partitions,
it is no possible
to initialize only an
individual partition.
The
Drive Initialize operation
wiU be performed on all
partitions of that disk drive
or other disk.
As needed, use
PARAMETER [ ◄◄ ] [ ►► ]
and the
TIMEA^ALUE dial
to make the following settings.
CONDITtON MARKER#
SVSPhysicalFnt= Off -
lEASURE BEAT
Physical Fmt fPhysical Format)
Select
whether
or
not
to
use
physical
formatting.
In
normal
circumstances,
set this to "Off." If a disk error is found with Surface Scan (p. 72), set this to
"On," then initialize the hard disk again.
CONOmON MAF«<ER#
SVS P.artition=1000MB -ds
BEAT
Partition
Select the partition size (500 MB or 1000 MB). In normal circumstances,
select "1000 MB."
70