Interlogix Concord Express Installation Manual - Manual (Page 17)

Chapter 1
Concord Express Installation Instructions 11
5. Install anchors where studs are not present.
6. Partially insert screws into the two top mounting hole locations, then hang the
panel on the two screws.
7. Recheck for levelness, insert the two lower screws, and tighten all four
mounting screws.
8. Install the antenna housing (included with the panel) by pushing it down into
the top left hole of the cabinet until it snaps into place (see Figure 3 below).
9. Install the circuit board into the cabinet, inserting the loop antenna loop up
into the antenna housing (see Figure 3 below), then secure the circuit board
with the four mounting screws (included).
Figure 3: Installing the antenna housing and the circuit board
Identify Panel Components
Before installing devices and making wiring connections, familiarize yourself with
the main components of the panel. Figure 4 on page 12 shows the main
component locations on the circuit board.