Interlogix Concord Express Installation Manual - Manual (Page 45)

Chapter 2
Concord Express Installation Instructions 39
Backup (0104-cs phone 1, 0114-cs phone 2) Phones-CS Phone 1-2 (Default: CS
Phone 1=on, CS Phone 2=off)
This setting determines whether or not the panel uses
another programmed central station phone number for
reporting if three initial attempts are unsuccessful.
CS Phone 1 is backed up by CS Phone 2, and CS Phone
2 is backed up by CS Phone 1. The panel makes up to 16
attempts (8 per phone number), alternating between the
two programmed phone numbers.
For example, if Backup is on and three failed reporting
attempts occur using CS Phone 1, the panel switches to
CS Phone 2 for three more reporting attempts. If these
attempts fail, the panel switches back to CS Phone 1 for
five more reporting attempts and, if necessary, switches
back to CS Phone 2 for five final attempts.
To turn Backup off or on:
1. With the display showing
BACKUP
OFF/ON
(current setting), press 1
(off) or 2 (on). The display
flashes the entered setting.
2. Press # and the display shows
the new setting.
Reporting Format (0105-cs phone 1,
0115-cs phone 2) Phones-CS Phone 1-2 (Default=all CID)
This setting determines whether the
panel uses the SIA or CID (Contact ID)
reporting format for central station
communication. To select SIA or CID Reporting Format:
1. With the display showing
REPORTING FORMAT
SIA/CID
(current setting), press 1 (for SIA) or 2 (for
CID). The display flashes the entered setting.
2. Press # and the display shows the new setting.
The following describes how to program the phone settings that appear under
PAGER PHONE 1-3.
Phone Number (0120-pager 1, 0130-pager 2,
0140-pager 3) Phones-Pager Phone 1-3 (Default=none)
This setting is used for programming a phone
number that communicates to a pager. Phone
numbers can be 1-24 digits long, and can include
pauses or * and # characters.
To enter pauses, press C. To enter *, press and
hold 7 for one second. To enter #, press and hold
9 for one second.
Note : Call-waiting services should be disabled to
prevent interruptions to panel communication to
the central monitoring station (or pager). To
program a dialing prefix that disables call-waiting,
see the Call Wait Cancel setting under the menu
PHONE OPTIONS—GLOBAL .
To program a Pager Phone Number:
1. With the display showing
PHONE NUMBER
_
(or current number), enter the desired
pager phone number including pauses.
The display flashes the entered number.
2. Press # and the display shows the new
number.
To delete a Pager Phone Number:
With the display showing
PHONE NUMBER _
(current number), press D. The display shows
PHONE NUMBER _
.