Interlogix Concord Express Installation Manual - Manual (Page 39)

Chapter 2
Concord Express Installation Instructions 33
Downloader Code (0000) Security-Global (Default = 12345)
The 5-digit downloader code is used in conjunction
with downloader programming. The down-loader
operator must have the panel account number and
downloader code in order to perform any
programming.
Note : The Downloader Code cannot be deleted from
panel memory. To change the Downloader Code
to its default setting, enter 12345 in the procedure
to the right. The Downloader Code will be reset to
defaults during a Memory Clear only if the Dealer
Code is not set OR if the Dealer Code is used to
initiate the Memory Clear.
To program a Downloader Code:
1. With the display showing
DOWNLOADER CODE nnnnn
(current code), enter the desired
5-digit code, + #. The display flashes
the entered code.
2. Press # and the display shows
DOWNLOADER CODE nnnnn (new
code).
Installer Code (0001) Security-Global (Default = 4321)
The 4-digit installer code is used for entering program
mode and changing system settings. If a dealer code
is programmed, only those settings not associated
with phone numbers can be changed.
Note : The Installer Code cannot be deleted or cleared
from panel memory. To change the Installer Code
to its default setting, enter 4321 in the procedure
above.
To program an Installer Code:
1. With the display showing INSTALLER
CODE nnnn (current code), enter the
desired 4-digit code + #. The display
flashes the entered code.
2. Press # and display shows
INSTALLER CODE nnnn (new code).
Dealer Code (0002) Security-Global (Default = none)
The 4-digit dealer code is used to prevent
unauthorized persons from changing the
programmed central station phone numbers
and the Downloader Access Code. When this
feature is enabled, central station phone
numbers and the Downloader Code cannot be
changed (unless you enter the program mode
by using the dealer code). All other system
settings are still accessible by entering the
program mode with the installer code. To program a Dealer Code:
1. With the display showing
DEALER CODE ****
,
enter the desired 4-digit code. The display
flashes the entered setting.
2. Press # and the display shows the new
code.
To delete a Dealer Code:
With the display showing
DEALER CODE nnnn
(current code), press D. The display shows
DEALER CODE ****
.
Note : The Dealer Code cannot be deleted by
clearing panel memory.