Interlogix Concord Express Installation Manual - Manual (Page 3)

A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the
applicable FCC Part 68 rules and requirements as adopted by ACTA. A compliant telephone cord and modular plug is
provided with this product. It is designed to be connected to a compliant modular jack that is also compliant. See the
Installation Instructions for details.
Alarm dialing equipment must be able to seize the telephone line and place a call in an emergency situation. It must be
able to do this even if other equipment (telephone, answering system, computer modem, etc.) already has the telephone
line in use. To do so, alarm dialing equipment must be connected to a properly installed RJ31X jack that is electrically in
series and ahead of all other equipment attached to the same telephone line. Proper install ation is depicted in the
following diagram. If you have any questions concerning these instructions, consult your local telephone company or a
qualified installer about installing an RJ31X jack and alarm dialing equipment for you.
If this equipment causes harm to the telephone network, the telephone company may temporarily disconnect your service.
If possible, you will be notified in advance. When advance notice is not practical, you will be notified as soon as possible.
You will also be advised of your right to file a complaint with the FCC.
The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the
operation of the equipment. You will be given advance notice in order to maintain uninterrupted service.
If you experience trouble with this equipment, please contact the company that installed the equipment for service and/or
repair information. The telephone company may ask you to disconnect this equipment from the network until the problem
has been corrected or you are sure that the equipment is not malfunctioning.
This equipment may not be used on coin service provided by the telephone company. Connection to party lines is subject
to state tariffs
Patent Information
This product and the use of this product may be covered by one or more of the following patents: 5,805,063, 5,872,512,
5,942,981, 4,855,713. Except expressly provided herein, the purchase of this product shall not constitute a license or
otherwise provide a right to practice a method covered by any of the identified patents. UTC Fire & Security hereby grants
the purchaser of this product a limited, non-exclusive license to practice the methods patented in the identified patents
solely with products manufactured, sold or licensed by UTC Fire & Security. This license grant does not extend to the use
of unlicensed, third party products with this product.
Canada notice
The Canadian Department of Communications label identifies certified equipment. This certification means that the
equipment meets certain telecommunications network protective, operational, and safety requirements. The department
does not guarantee the equipment will operate to the user’s satisfaction.