Interlogix Concord Express Installation Manual - Manual (Page 75)

Chapter 2
Concord Express Installation Instructions 69
System Version (30=factory
code, 31=system number,
32=system level) (Default=N/A)
This menu lets you view and
identify the panel hardware and
software version. To view and identify the System Version:
1. Enter user programming with the system master code.
The display shows USER CODES.
2. Press A or B until the display shows SYSTEM VERSION.
3. Press # and the display shows FACTORY CODE
nnn*nnnn.
4. Press B and the display shows SYSTEM NUMBER
*nnnnnnn.
5. Press B again and the display shows SYSTEM LEVEL
nnnn.
Downloader Programming
The panel can be programmed remotely using ToolBox. Use the information you
recorded in Appendix A to inform the downloading operator of your installation
programming requirements.
ToolBox Downloader Programming
Note : A Downloader Phone Number must be programmed and the user-
programmable option Downloading must be set to on in order for remote
downloader programming to work.
To initiate a ToolBox download session:
1. Contact your download station and ask the operator to prepare to download
to the panel.
2. Make sure the system is disarmed.
3. Press 8 + system master CODE + 7 + 0 (any), 1 (down), or 2 (up). The
display shows SYSTEM DOWNLOAD IN PROGRESS during the
downloading process.
If the alphanumeric touchpad does not display SYSTEM DOWNLOAD IN
PROGRESS, call the downloader operator to verify the downloader phone
number and that ToolBox is set up properly. Refer to the “Troubleshooting” on
page 76 if the problem persists.