Interlogix Concord Express Installation Manual - Manual (Page 65)

Chapter 2
Concord Express Installation Instructions 59
Sensor Text (071) Sensors (Default=none)
Use the following guidelines for programming
text to identify zone/sensor locations.
• There are 16 character/word locations or
“Item Numbers” for each zone/sensor
name. Item numbers for each
character/word appear in “Appendix A,
Table A4.”
• If a desired word does not appear in the list,
create it using characters (custom text).
• When using words, spaces between them
appear automatically. When creating words
using characters, you must reserve an item
number for a “space” after creating the
word.
• Each character or word uses up one item
number. For example, a word from the list
counts as one item number. A created
word, such as BOY’S counts as six item
numbers, 4 letters, 1 apostrophe, and 1
space.
• Plan ahead before programming sensor
text. You may need to abbreviate words
you create to avoid running out of item
numbers.
To program Sensor Text:
1. With the display showing LEARN
SENSORS, press B until the display shows
SENSOR TEXT.
2. Press # and the display shows TEXT FOR
SN 01.
3. Press # and the display shows SN 01 ITEM
00 000 -. Where ITEM 00 is the first
character/word location and 000 is the 3-
digit character/word number.
4. Enter the 3-digit number of the desired
character/word or scroll through the
numbers by pressing B (forward) or by
pressing A (backward). If you make a
mistake, simply enter the correct 3-digit
number or continue scrolling through
choices.
5. Press # to accept the displayed choice and
the display shows SN 01 ITEM 01 000 -.
6. Repeat steps 4 and 5 as needed to
complete the zone/sensor name.
7. Press * after entering the last 3-digit
character/word number. The display shows
the complete text name. For example, TEXT
FOR SN 01 FRONT ENTRY DOOR.
Delete Sensors (072) Sensors (Default=none)
The following describes how to remove
hardwire zone and wireless sensor
numbers from panel memory.
Note : Deleting sensors does not delete
sensor text associated with the deleted
sensor number. To delete sensor text,
enter the SENSOR TEXT menu and
enter 000 (nulls) for each item number.
To Delete Sensors from panel memory:
1. With the display showing LEARN SENSORS,
press B until the display shows DELETE
SENSORS.
2. Press # and the display shows DELETE SENSOR
nn (lowest zone/sensor number in panel memory).
3. Press # to delete the displayed sensor or enter the
desired sensor number, then press #. The display
flashes the entered number, then stops and shows
DELETE SENSOR NN DONE.
4. Repeat steps 2 and 3 until all desired sensors are
deleted.