Moog Crossbow NAV440 Series - Manual (Page 41)

NAV440 User Manual
7430‐0131‐01 Rev. F
Page 41
Chapter 5. Installation Guidelines
This ch laboratory test. apter provides information to set up the 440 Series unit and NAV‐VIEW 2.2 software for
NOTE: D a unit in a vehicle for field use is outside the scope of this document. irections to install
• Overview, page41
•
n Requi Installatio rements, page 41
• 1. Install Software —NAV‐VIEW 2.2, page 42
• age 2.Prepare the Communication Port, p
•
42
3. Connect the GPS Antenna, page 42
• 4. Turn on the 440 Series , page 42
Overview
The following instructions are for connecting the 440 Series unit to a computer and using NAV‐VIEW 2.2 to verify
basic functions of the unit in a laboratory setting.
Installation Requirements
Computer
• CPU: ≥ 1GHz
• RAM Memory: ≥ 3GB
• Hard Drive Free Memory: ≥ 60MB
•
XP, 32 bit or 64 bit; Windows 7, 32 bit or 64 bit Operating System: Windows
• Microsoft .NET 4.0 or higher
Communication Port
• Determine which COM port to use.
Power and Hardware
Power:
• to +42 VDC Voltage: +9 VDC
• Power: > 5 W
Hardware:
• Ensure all necessary hardware has been determined and provided.
• Optional: For laboratory test, use the cable provided with the Moog Crossbow evaluation kit. (Refer to
Figure 27 on page 124.)
The evaluation kit cable is only suitable for laboratory test; it is not designed for field use. Refer to NOTE:
Figure 27 Evaluation Kit 440 Series Cable