Moog Crossbow NAV440 Series - Manual (Page 45)

NAV440 User Manual
7430‐0131‐01 Rev. F
Page 45
Chapter 6. Viewing and Logging Data with NAV‐VIEW 2.2
It is assumed that 440 Series and NAV‐VIEW 2.2 have been set up, connected and turned on. For instructions, NOTE:
re . fer to Chapter 5. Installation Guidelines on page 41
Figure 8on page 46shows the main page of NAV‐VIEW.
p of the page. The functions are available from the menu bar at the to
The graphs are displayed in the main body of the page.
• Multiple graphs can be selected for viewing. Which graphs are available depends on the packet type that
was selected. For details about packet types, refer to Chapter 9. Communicating with the 440.
seconds per time frame. • The time range (speed) of viewing the graphs can be selected: 2, 5, 10, 20, or 50
The bott the unit and connection to the unit om of the page indicates information about
• connected to the COM port That the unit is
• The baud rate
•
cted and working, the following messages will be displayed: If the unit is conne
ted” “Unit Connec
Packet Rate
Series unit The serial number of the 440
The version of NAV‐VIEW 2.2
If the unit is not connected, the following message
ill be displayed: w
If Unit Not Connected is displayed, check the
following:
• Are the power supply levels are correct.
• Verify that the setting of the serial Port.
Figure 7 No Display