Moog Crossbow NAV440 Series - Manual (Page 42)

Pag 2 NAV440 User Manual
7430‐0131‐01 Rev. F
e 4
1. Install —NAV‐VIEW 2.2
Software
Inst ct ru ions
a. Insert the CD 440 Series Inertial System in the CD‐ROM drive.
. b. On the CD, navigate to the NAV‐VIEW 2.2 folder and double click the setup.exe file
c. Follow the wizard instructions to install NAV‐VIEW 2.2 and .NET 4.0 framework.
2. Prepare the Communication Port
• The 440 Series unit communicates directly to the computer or host via serial port: determine which
communication port to use.
• Setting up the port will be handled in step 4Turn on the 440 Series .
3. Connect the GPS Antenna
ternal active a NOTE: The 440 Series unit is shipped with an ex ntenna.
To clearly receive signals from many satellites, a clear view from the antenna to the sky is required.
• Poor visibility may result in position drift or a prolonged Time‐To‐First‐Fix (TTFF). The following setups
can obstruct the signal, resulting in poor results for navigation:
• The GPS receiver will not work properly if signals are blocked, such as objects cover the antenna, or the
receiver is located underground or other confined area.
• mming. Signals can also be blocked or distorted with a poor quality antenna or RF cable, or in‐band ja
• Placing the antenna on a 16square inch (e.g. 4” x 4”) or larger ground plane is recommended.
Instructions
• Secure the antenna to the SMA jack on the enclosure.
4. Turn on the 440 Series
Inst ct ru ions
n +9 VDC and +42 VDC, and then turn off the a. Ensure the voltage level of the power supply is set betwee
power supply.
it. b. Secure the DB‐15 end of the cable to the 440 Series un
c. Secure the DB‐9 end of the cable to the host computer.
d. Con
DC voltage power supply: nect the input power (red and black wires) to the
• Connect the red plug to the positive terminal (+)
• Connect the black plug to the ground terminal (‐) ground.
CAUTION: If the input power leads are reversed, the unit may be damaged. The warranty for the unit does not
cover damage cause by neglect or incorrect use; Moog Crossbow will assume no responsibility for the
repair or replacement of the unit.
e. Turn on the power supply. Ensure the total power drawn does not exceed 5 watts.