Moog Crossbow NAV440 Series - Manual (Page 51)

NAV440 User Manual
7430‐0131‐01 Rev. F
Page 51
Chapter 7. Configuring the 440 Series with NAV‐VIEW 2.2
It is assumed the 440 Series unit and NAV‐VIEW 2.2 have been set up. For instructions to do so, refer to Chapter 5.
Installation Guidelines.
This section provides instructions to configure the unit via NAV‐VIEW 2.2, a GUI application. For information about
configuring the unit via programming code, refer to Chapter 10. Programming Guidelines.
NOTE: It is recommended to read and thoroughly understand the affects of altering the settings in the Advanced tab
be tion. Refer to fore making changes to the unit configura Chapter 2. 440 Series Functions.
• s Viewing Current Configuration
• ge
, page 51.
Configuring the Unit, pa
The configur 52
ation tabs:
o
General, page 52
o
Advanced, page53
o
BIT Configuration, page 54
o
Aligning the Magnetometer, page 55
Viewing Current Configurations
nt settings and calibration data. The displayed information can be printed. NAV‐VIEW 2.2 allows viewing the curre
There are two methods to view current
configuration.
Method 1:
• At the main screen, select Unit
Configuration nu bar, then
enu.
from the me
select Print from the drop m
The dialog window opens (Figure 14).
Figure 14 Current Configuration