Ditch Witch JT20 - Manual (Page 125)

Systems and Equipment - 124
JT20 Operator’s Manual
Tracker Control
CMW
®
Operation
Enable Tracker Control
1. Start drilling unit.
2. Ensure that tracking unit is paired to tracking display and enable tracker control. See tracking system
operator’s manual for instructions.
3. Remove tracker control key (shown) from set-up
console at rear of drilling unit. Keep in tracker
operator’s possession.
4. Drill and track bore.
Troubleshooting Tip: If thrust and rotation are not
enabled:
• Check whether the green tracker control light
located on drilling unit anchoring console (shown)
is on. If it is, communication has probably stopped
between tracker and display, or tracker is set to
incorrect code.
• If communication cannot be restored, install
tracker control key in drilling unit and rotate
clockwise. Green tracker control light located on
anchoring console will go off. Thrust and rotation
will function.
NOTICE: Tracker operator cannot disable thrust and
rotation from tracker if tracker control key is installed in
drilling unit and turned to the disable position. See
“Tracker control key” on page 26 for more information.