Ditch Witch JT20 - Manual (Page 81)

Transport - 80
JT20 Operator’s Manual
Lift
CMW
®
Lift
This machine is not configured for lifting. If the machine must be lifted, load machine into a container or
onto a platform appropriate for lifting. See “Specifications” on page 185 for weight of machine.
Haul
Load
With Tiedown Kit
1. Start drilling unit engine.
2. Using tethered ground drive controller, pull power mode switch into low position.
3. Move drilling unit to rear of trailer and align with ramps.
4. Slowly drive unit onto trailer until track reaches chock.
5. Lower drill frame to drill frame rest.
6. Back unit until front of drill frame is seated in rest.
7. Lower stabilizers to trailer floor.
8. Stop engine.
9. Attach tiedowns at rear of unit where indicated on page 81.
Without Tiedown Kit
1. Start drilling unit engine.
2. Using tethered ground drive controller, pull power mode switch into low position.
3. Move drilling unit to rear of trailer and align with ramps.
4. Slowly drive unit onto trailer until track reaches chock.
Crushing weight. If load falls or moves it could kill or crush you. Use
proper procedures and equipment or stay away.
To help avoid injury,
• Attach trailer to vehicle before loading or unloading.
• Verify that trailer wheels are blocked.
• Load and unload trailer on level ground.
• Load trailer correctly to prevent trailer swaying. Place 10-15% of total vehicle weight (equipment
plus trailer) on tongue.