Ditch Witch JT20 - Manual (Page 180)

JT20 Operator’s Manual
Service - 179
As Needed
CMW
®
As Needed
Change Auto Lubricator TJC Pail
Check pipe auto lubricator TJC level and change
pail as needed.
To change pail:
1. Remove wingnuts and bolts attaching base
ring (4) to pail cover (1).
2. Rotate base ring slightly to clear hooks on
cover and remove pail from cover.
3. Remove follower plate (3) from empty pail
and install into new pail. Press firmly on
follower plate until TJC comes up in center
opening.
4. Remove base ring from empty pail and install onto new pail.
5. Install pail into place over pump dip tube. Use hooks on cover to support base ring.
6. Install bolts and wingnuts.
7. Remove cap (2) from discharge tee on pump. Operate pump until discharged TJC is free of air
pockets. Replace cap.
Task Notes
Change pipe auto lubricator pail TJC
Change hydraulic filter Any time system is opened
Check pipeloader pads
Check front pipe guide inserts
Check fluid pump ball valve
Check track tension and condition
Change/Adjust engine drive belt
Change air filter
Check saver sub
NOTICE: Use only genuine Ditch Witch
®
tool joint compound to maintain warranty. See “Recommended
Lubricants/Service Key” on page 159 for more information.
j38om016w.eps