Ditch Witch JT30AT - Manual (Page 144)

JT30 /JT30 All Terrain Operator’s Manual
Systems and Equipment - 144
Tracker Control
CMW
4. Turn on tracker and check four-digit code.
If codes on tracker and display match, thrust and
rotation hydraulics on the drilling unit are enabled.
If codes on tracker and display do not match, adjust
tracker code:
• Press and hold fore/aft/left/right button while
making the following adjustments.
• Use ON/OFF to advance first two digits (1). Use
DEPTH to lower first two digits.
• Use up arrow to advance last two digits (2). Use
down arrow to lower last two digits.
• Press and hold each button to advance or lower
value quickly.
• To start sending code from the tracker to the
display, press and hold fore/aft/left/right button
and press MODE. Thrust and rotation hydraulics on the drilling unit are now enabled.
5. Remove tracker control key (shown) from set-up console at rear of drilling unit. Keep in tracker
operator’s possession.
6. Drill and track bore.
Troubleshooting Tip: If thrust and rotation are
not enabled:
• Check whether the green tracker control
light located on drilling unit anchoring
console is on. If it is, communication has
probably stopped between tracker and
display, or tracker is set to incorrect code.
• If communication cannot be restored,
install tracker control key (shown) in drilling
unit and rotate clockwise. Green tracker
control light located on anchoring console
will go off. Thrust and rotation will function.
NOTICE: Tracker operator cannot disable
thrust and rotation from tracker if tracker
control key (shown) is installed in drilling unit
and turned to the disable position.