Ditch Witch JT30AT - Manual (Page 202)

JT30 /JT30 All Terrain Operator’s Manual
Service - 202
Recommended Lubricants/Service Key
CMW
Approved Fuel
Tier 4i Engine (U.S., Canada, EU, and Japan)
This engine is designed to run on diesel fuel. Use only high quality fuel meeting ASTM D975 No. 2D,
EN590, or equivalent. At temperatures below 32° F (0° C) winter fuel blends are acceptable. See the
engine operation manual for more information.
Biodiesel blends up to 5% (B5) are approved for use in this unit. The fuel used must meet the
specifications for diesel fuel shown above. In certain markets, higher blends may be used if certain steps
are taken. Extra attention is needed when using biodiesel, especially when operating in cold weather or
storing fuel. Contact your Ditch Witch dealer or the engine manufacturer for more information.
Tier 3 Engine (Rest of World)
This engine is designed to run on diesel fuel. Use only high quality fuel meeting ASTM D975 No. 2D,
EN590, or equivalent. At temperatures below 32° F (0° C) winter fuel blends are acceptable. See the
engine operation manual for more information.
Biodiesel blends up to 5% (B5) are approved for use in this unit. The fuel used must meet the
specifications for diesel fuel shown above. In certain markets, higher blends may be used if certain steps
are taken. Extra attention is needed when using biodiesel, especially when operating in cold weather or
storing fuel. Contact your Ditch Witch dealer or the engine manufacturer for more information.
NOTICE: Use only Ultra Low Sulfur Diesel (less than 15ppm sulfur content) in this unit. Operating with
higher sulfur content will damage the engine and aftertreatment device.
IMPORTANT: Worldwide, fuel sulfur regulations vary widely. Fuel used should always comply with local
regulations. Prior to shipping, Tier 3 units were filled with Tier 4i DEO. If operating fuel with sulfur
content above 15 ppm (0.0015%), change oil initially at 250 hours.