Echelon LonPoint Application and Plug-In - Manual (Page 128)

10-26 Scheduler Interface
When this option is selected, the digital output names must match the event
names as described in Defining Inputs and Outputs earlier in this chapter. The
outputs must be named as described in Assigning Input/Output Names in the
next section, and at least one state with one exit condition must be defined, even
if you are not using the Mode_Out output from the State Machine functional
block.
Configuring a State Machine
Three tabs are used to configure a state machine. The Name I/O tab is used to
define names for each of the network variable inputs and outputs for the State
Machine functional block; the Edit State Machine tab is used to define the states
and transitions for the state machine; and, the Edit Conditions tab is used to
define the exit conditions.
Assigning Input/Output Names
The Name I/O tab, shown in the following figure, allows you assign names to
each of the State Machine functional block input and output network variables
and to define System Parameters.