Echelon LonPoint Application and Plug-In - Manual (Page 132)

10-30 Scheduler Interface
2. Click the Current State field. For each bubble in your bubble diagram, enter
the name of the state and press the Enter key. The new state is added to the
States list.
3. Select the initial state identified in your bubble diagram in the Select Initial
State field. Warning: If you forget to select an initial state, your schedule
will not simulate or operate correctly.
4. Click the Exit Conditions field. For each line in your Condition Definitions
shape(s), enter the exit condition name and press the Enter key. The new
exit condition name is added to the Exit Conditions list.
For each of your State Transition Definition shapes, follow these steps:
1. Select the state name in the Current State list.
2. For each row of the definition, click on a blank row in the transition table,
then click on the entries in the Exit Conditions, States, and Output Modes
lists that match the entries in your design. Also click on any outputs that
you have defined to be On for the transition.
The following figure shows the state machine definition for the stUnoccupied
state defined in the schedule design described in Defining State Transitions.