Echelon LonPoint Application and Plug-In - Manual (Page 137)

The LonPoint Application and Plug-in Guide 10-35
To start a new design, or to save or load a design file, select the Load/Save tab.
The following buttons are used to create, load, and save design files:
To create a new design, click the New Design File button. This clears all entries
on the Schedule Maker tabs so that you can create a new design.
To save a design, follow these steps:
1. Click the Save Design File button.
2. Locate a drive and folder for the schedule design file.
3. Enter a file name. You do not have to type the .DSG extension.
4. Click Save. The design is saved in the selected file.
To load an existing design file, follow these steps:
1. Click the Load Design File button.
2. Locate the drive and folder that contains the schedule design file.
3. Click the file you want to load.
4. Click Open. The design saved in the file is loaded to the LonPoint Schedule
Maker tabs.
Simulating a Supervisory Application Design
The LonPoint Schedule Maker simulator allows you to verify a supervisory
application design before downloading the design to an SCH-10 module. Designs
should always be simulated before downloading to verify that the SCH-10