Echelon LonPoint Application and Plug-In - Manual (Page 71)

The LonPoint Application and Plug-in Guide 7-5
Mode Default This value will be used if the Mode network variable
is not connected or has not received an update since
the last device reset.
Enable Default This value will be used if the Enable network
variable is not connected or has not received an
update since the last device reset.
Output Default This value will be sent to the physical actuator if the
functional block is disabled or has detected a
heartbeat failure.
Override This value will be sent to the hardware output if the
functional block is put into override.
Presets
This tab appears as follows:
This tab allows you to set up the preset table that determines how the Analog
output behaves for each mode value. Each value in the View Mode list
corresponds to a mode value. For each value that may be received by the Mode
network variable, you can specify whether the output value to the actuator will
be taken from the Analog input network variable or set to a preset value. Select
Use Network Variable
to use the network variable value for the selected
mode. Select Use Preset Value to use the specified preset value.