Echelon LonPoint Application and Plug-In - Manual (Page 36)

3-10 Digital Input/Counter Functional Block
Frequency Filter Length This parameter is only used if the processing option is
set to Frequency. This value may be set from 1 to
255 and determines the number of readings that are
sampled and averaged before a value is passed to the
Analog network variable.
Default Control Value This parameter is only used if the processing option is
set to Count, Repeating Count, or On Time. This
value determines the control value if the Control
input network variable is not connected or has not
received an update since the devices last reset.
Translation
This tab appears as follows:
This tab is only used if the Frequency processing option is selected and the
Translation
option is selected in the Digital Input/Counter tab.
This tab allows you to set up a translation table which translates the raw
measured data into the values to be sent by the Analog output network variable
after filtering (see the Frequency processing option, earlier in this chapter).
The translation table provides a means for mapping any input set of values into a
different set of output values via pairs of input/output values. The Digital