Echelon OpenLNS - Manual (Page 525)

OpenLNS Programmer's Reference 488
priorityValue A Boolean value.
TRUE. Priority is used when
polling or explicitly
updating a message
monitor point using the
Value property .
FALSE. Priority is not used .
monOptsObject The MsgMonitorOptions to be acted
on.
Data Type Boolean.
Read/Write Read/write.
Added to API LNS Release 3.0.
Retries
Summary Specifies the number of retries to use for acknowledged,
request/response, or repeated service messages. This applies
to network management messages only .
Setting this property through the NvOptions or MsgOptions
properties of a permananent monitor set, or through the
CurrentOptions property of a permanent monitor point, does
not have an effect. The default retry count to use for all
permanent network variable and message monitor points is
established by the RetryCount property of the
ConnectDescTemplate specified when the monitor point was
created.
You cannot set this property through the DefaultOptions
property of a temporary monitor point, as the CurrentOptions
properties of all temporary monitor points are not accessible.
However, you can set this property through the NvOptions or
MsgOptions property of a temporary monitor set to determine
the default retry count that will be applied to all temporary
monitor points as they are added to the set.
You can also set this property through the CurrentOptions
property of a permanent or temporary monitor point to
determine what retry count for the current monitoring
session.
See the Monitor and Control chapter of the OpenLNS
Programmer’s Guide for more information.
Availability Local, full, lightweight, and independent clients. Note that
temporary MonitorSet objects and temporary monitor points
are not available on Independent clients.
Syntax retryValue = monOptsObject.Retries
Element Description
retryValue The number of retries. The valid
range of values for this property is