Echelon OpenLNS - Manual (Page 987)

OpenLNS Programmer's Reference 950
name used for these custom interfaces is
"LcaUpgrade<n>", where <n> is a
sequential number reflecting the number
of upgrades that the device has gone
through since LNS 3.20 was installed. For
example, the 3rd time the device is
upgraded, this interface would be named
"LcaUpgrade3." Note that static
components are converted to dynamic
components only if the new interface
supports dynamic LonMark Objects, and
the old interface did not.
4096 lcaUgRsCapacity
The external interface component was
deleted because it did not fit in the new
external interface. This only applies to
dynamic network variables, message tags,
monitor sets, and monitor points which
could not be mapped or recreated because
the new external interface has a lower
capacity.
8192 lcaUgRsNonExistent
The external interface component was
deleted because no matching component
could be found in the new external
interface.
16384 lcaUgRsNoOwner
The monitor point was deleted because the
network variable it was monitoring does
not exist. The monitor set will still be
re-created, even if its member monitor
points could not be.
32768 lcaUgRsNoMember
The monitor point was deleted because the
network variable it was monitoring was
deleted, or the address table entry the
monitor point was using was deleted.
uiObject The UpgradeInfo object to be acted on.
Data Type Long.
Read/Write Read only.
Added to API LNS Release 3.0.