BINDER FDL 115 - Manual (Page 15)

FDL (E2.1) 02/2015 page 15/75
If a warning signal indicates an error condition, no further charging material must be introduced into the
unit.
DANGER
Explosion and ignition hazard.
Danger of death.
∅
Do NOT introduce any further charging material as long as there is a warning signal.
During and after the drying process, the inner surfaces have got a temperature close to the set-point.
CAUTION
The inner chamber, the exhaust duct, the door gasket, and the access ports will be-
come hot during operation.
Danger of burning.
∅
Do NOT touch the inner surfaces, the exhaust duct, the door gasket, the access ports,
or the charging material during operation.
1.6 Intended use
The BINDER safety drying oven FDL 115 is suitable for drying and burn in of lacquers and similar liquid
coating materials which are containing solvents that can form explosive mixtures with air. The maximally
permitted drying temperature and the maximally permitted quantity of solvent are limited, see chap. 1.9.
The FDL is also suited for coil coating / hot air short cycle applications.
Other applications are not approved.
Do NOT use the unit to warm up coating materials in containers, vessels, etc. or for drying textiles
soaked in solvent.
Do NOT use the unit for drying purpose if greater quantities of steam or solvent gas leading to condensa-
tion will be set free.
Following the instructions in this operating manual and conducting regular maintenance work
(chap. 14.1) are part of the intended use.
The charging material shall not contain any corrosive ingredients that may damage the ma-
chine components made of stainless steel, aluminum, and copper. Such ingredients include in
particular acids and halides. Any corrosive damage caused by such ingredients is excluded
from liability by BINDER GmbH.
1.7 Operating instructions
Depending on the application and location of the unit, the operator of the safety drying oven must provide
the relevant information for safe operation of the unit in a set of operating instructions.
These operating instructions must be kept with the unit at all times in a place where they are
clearly visible. They must be comprehensible and written in the language of the employees.