BINDER FDL 115 - Manual (Page 22)

FDL (E2.1) 02/2015 page 22/75
In case of too high drying temperature and /or too high quantity of solvent in the steam room it could be
possible that the concentration of the solvent steam will lead to an explosion. The permitted maximum of
solvent brought into the drying oven and the maximal temperature must not be exceeded.
DANGER
Excessive drying temperature and/or excessive solvent quantity.
Danger of explosion.
Danger of death.
∅
Do NOT exceed the maximum solvent quantity.
∅ Do NOT exceed the maximum drying temperature for the solvent quantity.
Adjust the temperature safety device according to the selected set-point (chap. 12.1).
3. Completeness of delivery, transportation, storage, and installa-
tion
3.1 Unpacking, and checking equipment and completeness of delivery
After unpacking, please check the unit and its optional accessories, if any, based on the delivery receipt
for completeness and for transportation damage. Inform the carrier immediately if transportation damage
has occurred.
The final tests of the manufacturer may have caused traces of the shelves on the inner surfaces. This
has no impact on the function and performance of the unit.
Please remove any transportation protection devices and adhesives in/on the unit and on the doors and
remove the operating manuals and accessory equipment.
CAUTION
Sliding or tilting of the unit.
Damage to the unit.
∅
Do NOT lift or transport the unit using the door or the handle.
 Lift the unit from the pallet at the four lower corners with the aid of four people.
If you need to return the unit, please use the original packing and observe the guidelines for safe lifting
and transportation (chap. 3.2).
For disposal of the transport packing, see chap. 15.1.
Note on second-hand units (Ex-Demo-Units):
Second-hand units are units that were used for a short time for tests or exhibitions. They are thoroughly
tested before resale. BINDER ensures that the chamber is technically sound and will work flawlessly.
Second-hand units are marked with a sticker on the unit door. Please remove the sticker before commis-
sioning the unit.