Casella CEL CEL-440 - Manual (Page 6)

Chapter . . . . . . . . . . . . . . . . . . . Page
4.5.2 Replay . . . . . . . . . . . . . . . . . . . . . . . . 52
5. SPECIFICATION . . . . . . . . . . . . . . . . . . 55
5.1 CEL-440 . . . . . . . . . . . . . . . . . . . . . . . 55
5.2 CEL-480 . . . . . . . . . . . . . . . . . . . . . . . 61
5.3 Filter Scanning . . . . . . . . . . . . . . . . . . . 62
5.4 Compliance . . . . . . . . . . . . . . . . . . . 66
6. PARTS & WARRANTY . . . . . . . . . . . . . . 67
6.1 Schedule of Parts . . . . . . . . . . . . . . . . . . 67
6.2 Instrument Servicing & Warranty . . . . . . . . . . 68
Getting Started
The following steps are suggested to get your CEL-440 or CEL-480
started.
1.
Refer to Sections 1.1 and 1.2 to learn what is shown on the
display and how to use the Quick Edit function.
2. Install the microphone, preamplifier and batteries according to
Section 1.3.
3. Switch the instrument ON and follow the preliminary messages
as described in Section 1.4.
The messages indicate the instrument type and version.
4. Check “Hints for using Menus” between Chapters 1 and 2.
5. Select the display language and microphone response according
to Section 2.1.
6. Perform an acoustic calibration check as detailed in Section 2.2.
7. Select a bandwidth, run timing and pre-set measurement set-up
according to Chapter 3.
8. Start measurement and data logging as described in Section 4.1.
9. Recall stored data (and print) it according to Section 4.2.
10. Record data on a tape or DAT recorder and replay it as described
in Section 4.5.
Page 6 - CEL-440/480 Operators Handbook
Contents